What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
15.06.2025 02:58

Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
What is lightning?
Barnstars:
nine
What do dreams about dead people mean?
He then describes the function of a fuse.
the problem then depends on "how fast does the fuse operate?".
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
What caused North Korea to go poor when at first it was rich?
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
He then describes Rainy Season and Lightning.
There are three different concepts here that are getting confused.
Here is a simplified AC power diagram.
How do you get a girl to like you?
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
First Sentence:
(Dc diagram shown, AC is similar).
What was your biggest culture shock going to Europe?
At one ohm, the resistor has a maximum of 1 watt power.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
Because the load is inductive, the current lags the voltage.(by a bit).
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
This is where this question deviates from being a 'generic' question, and becomes more specific.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Why does a lot of the YouTube community support the MGTOW movement?
For this case there are devices called Metal oxide varistors (MOV).
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Now when you have a certain ac resistance, then a current flows in a loop.
Why do White people love dogs more than humans?
What does a fuse do?
One is “what exactly is in a ‘surge protector’ ? ”
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Can you provide some examples of music with a free form structure?
A circuit breaker is similar, but is resettable.
It also is a device that limits the change in current flow.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
This is where the MOV conducts again, and dissipated the energy.
One
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
These are simplified answers to the original question, and does not change anything I wrote above.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
[old diagram got deleted by accident]
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
what exactly is a ‘surge’ protector?
Upvotes:
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
There are two important concepts here.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
An AC voltage/ current source, and an ac inductive load.
but I think this circuit , shows a few more pieces.
But… the neutral is now “floating” because of the 1 ohm resistance.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
It seems Mohan does not understand the difference between a comment and an Answer.
but this device (an Inductor) … impedes the rapid changes in the current.
These devices are installed between the “hot” and “neutral” and protective ground.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
At least they know the answer if they wanted it.
2024–10–10[John johnson John Johnson ]
A fuse is a non-resetable over current circuit protector.
This is 'the assistant's answer'
This one hit behind the barn.
[image of Common-mode choke]
But it can get overloaded, and no longer works.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
The bolt then partially travels down the line to your home.
2024–10–14 [Omar Gharbi Omar Gharbi ]
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
I post the exact comment here.
eight
This device then solves the entire problem.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
The MOV will conduct when the voltage exceeds 50% of line voltage.
In schematic diagrams this is the symbol for a fuse:
2024–10–16 [ OO OLAOYE OYEBODE ]
He then asserts :
The other is “what does a “fuse” do?”
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
The third is lightning and “how it gets conducted into a home.”
a photo is worth a thousand words.
so, what happens?
Edit 2024–10.
So, the voltage could go up to 500 volts, and the fuse will not open up.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.